DTC C1232/32 Stuck in Deceleration Sensor |
DTC C1234/34 Yaw Rate Sensor Malfunction |
DTC C1244/44 Open or Short in Deceleration Sensor Circuit |
DTC C1279/79 Deceleration Sensor Output Voltage Malfunction (Test Mode DTC) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1232/32 | When any of following conditions detected:
|
|
| C1234/34 | Sensor malfunction signal received from yaw rate sensor |
|
| C1244/44 | G sensor forward and backward operation is malfunctioning (4WD) |
|
| C1279/79 | Detected only during test mode |
|

| 1.CHECK DTC |
Clear the DTC(s) (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC(s) is output.
Drive the vehicle at a speed of 30 km/h (19 mph) or more and check that no DTCs are output.
| Result | Proceed to |
| DTC is output (relating to yaw rate and deceleration sensor) | A |
| DTC is output (relating to CAN communication system) | B |
| DTC is not output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK YAW RATE SENSOR INSTALLATION |
![]() |
Check that the yaw rate sensor has been installed correctly (Click here).
|
| ||||
| OK | |
| 3.INSPECT YAW RATE SENSOR |
Remove the 2 nuts of the sensor bracket and yaw rate sensor with the connector connected .
Connect the Techstream to the DLC3.
Turn the Techstream ON.
Select the Data List mode on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Deceleration Sensor2 | Acceleration sensor 2 reading / min.: -18.183 m/s2, max.: 18.183 m/s2 | Approximately -1.280 to 1.270 m/s2
while stationary | Reading changes when vehicle is bounced. |
![]() |
Place the yaw rate sensor as shown in the illustration and turn the sensor to the right and left.
Check that the deceleration value of the deceleration sensor displayed on the Techstream changes.
|
| ||||
| OK | |
| 4.CHECK YAW RATE SENSOR TERMINAL VOLTAGE |
![]() |
for 4WD:
Disconnect the O12 sensor connector.
for 2WD:
Disconnect the O11 sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O12-3 (VYS) - O12-5 (GYAW) | Ignition switch ON | 11 to 14 V |
| Tester Connection | Switch Condition | Specified Condition |
| O11-3 (VYS) - O11-5 (GYAW) | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O12-5 (GYAW) - Body ground | Ignition switch ON | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| O11-5 (GYAW) - Body ground | Ignition switch ON | Below 1 Ω |
|
| ||||
| OK | ||
| ||