DTC C1340/47 Center Differential Lock Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1340/47 | When the terminal IG1 voltage is between 10 and 14 V, there is an open in the center differential lock detection switch circuit or there is a transfer mechanical malfunction for 2 seconds or more. |
|

| 1.INSPECT SKID CONTROL ECU (EXI2 TERMINAL) |
Set the vehicle in the 4WD with center differential locked state using the center differential lock detection switch.
![]() |
Disconnect the A19 ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-11 (EXI2) - Body ground |
| Below 1.5 V |
Connect the A19 ECU connector.
Set the vehicle in the 2WD or 4WD with center differential free state using the center differential lock detection switch.
Disconnect the A19 ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-11 (EXI2) - Body ground |
| 10 to 14 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4WD CONTROL ECU) |
![]() |
Confirm that the skid control ECU connector and 4WD control ECU connector are properly connected.
Disconnect the A19 and A28 ECU connectors.
Disconnect the D45 transfer shift actuator connector.
Inspect both the connector case and the terminal for deformation and corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-11 (EXI2) - A28-14 (4WD) | Always | Below 1 Ω |
| A19-11 (EXI2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (4WD CONTROL ECU - BODY GROUND) |
Confirm that the 4WD control ECU connector and transfer shift actuator connectors are properly connected.

Disconnect the A28 ECU connector.
Inspect the connector case and the terminal for deformation and corrosion.
Connect the A28 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A28-14 (4WD) - Body ground | 4WD with center differential locked (Center differential lock detection switch ON) | Below 1 Ω |
| 2WD or 4WD with center differential free (Center differential lock detection switch OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTC(s) (Click here).
Start the engine.
Check if the same DTC(s) is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||