FUEL PRESSURE REGULATOR > INSTALLATION |
| 1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY |
Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator.
![]() |
While turning the pressure regulator left and right, install it to the delivery pipe.
![]() |
Install the 2 bolts.
![]() |
Connect the vacuum sensing hose to the pressure regulator.
![]() |
Connect the No. 2 fuel tube to the pressure regulator (Click here).
| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 3. INSTALL AIR CLEANER HOSE ASSEMBLY |
![]() |
Install the air cleaner hose with the 2 clamps.
Connect the ventilation hose and vacuum sensing hose.
| 4. INSTALL V-BANK COVER |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.
| 5. CHECK FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.