Home › Engine / Hybrid System ยท 1UR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
  1. Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
  2. After discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.

  1. Disconnect the cable from the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



    A240791E01
  1. Turn the lock lever and disconnect the connector of the fuel pump ECU.
    Text in Illustration 
    *1
    Lock Lever

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine. After the engine has stopped on its own, turn the ignition switch off.

    HINT:
    DTC P0171/0174 (system too lean) may be set.

  1. Crank the engine again, then check that the engine does not start.

  1. Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.



    A240793E01
  1. Connect the connector of the fuel pump ECU.

  1. Turn the lock lever and secure the connector with the lock lever.
    Text in Illustration 
    *1
    Lock Lever



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE V-BANK COVER


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



5. REMOVE AIR CLEANER HOSE ASSEMBLY


    A214569
  1. Disconnect the vacuum sensing hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A161399
  1. Disconnect the No. 2 fuel tube from the pressure regulator (Click here).

    CAUTION:
    Put a cloth or equivalent under the pressure regulator.



    A161400
  1. Disconnect the vacuum sensing hose from the pressure regulator.



    A161401
  1. Remove the 2 bolts, and pull out the pressure regulator.

  1. Remove the O-ring from the pressure regulator.