Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E231654E02


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY


    E231655E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I49-5 (MIC-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I49-3 (MACC) - Body ground
    Ignition switch ACC
    4.75 to 5.25 V

Text in Illustration 
*a
Component with harness connected
(Navigation Receiver Assembly)


NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
  1. Disconnect the I49 navigation receiver assembly connector.

  1. Disconnect the U7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I49-3 (MACC) - U7-10 (ACC)
    Always
    Below 1 Ω
    I49-2 (MIC+) - U7-9 (MIC+)
    Always
    Below 1 Ω
    I49-5 (MIC-) - U7-8 (MIC-)
    Always
    Below 1 Ω
    I49-1 (SNS2) - U7-14 (SGND)
    Always
    Below 1 Ω
    I49-3 (MACC) - Body ground
    Always
    10 kΩ or higher
    I49-2 (MIC+) - Body ground
    Always
    10 kΩ or higher
    I49-5 (MIC-) - Body ground
    Always
    10 kΩ or higher
    I49-1 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone assembly with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE IS FAULTY)