Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Television Display Assembly Communication Error

for Preparation Click here


WIRING DIAGRAM


E189530E12


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E110917E20

  1. Press the preset switch "channel 2" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "190 (radio receiver assembly)" is the component shown by the sub-code in the example shown in the illustration.
    2. For details of the DTC display, refer to "DTC Check/Clear" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    HINT:
    The "Bluetooth" handsfree module is built into the radio receiver.


    Component Table 
    Component
    Proceed to
    Radio receiver assembly (190)
    Radio Receiver Power Source Circuit (Click here)
    Satellite radio tuner (1F1)
    "Bluetooth" handsfree module (19D)
    Stereo component amplifier assembly (440)
    Stereo Component Amplifier Power Source Circuit (Click here)
    Multi-media interface ECU (388)
    Multi-media Interface ECU Power Source Circuit (Click here)


NEXT


3.INSPECT RADIO RECEIVER ASSEMBLY


    E145834E25
  1. Disconnect the I4 and I8 radio receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I4-5 (ATX+) - I4-15 (ATX-)
    Always
    60 to 80 Ω
    I8-9 (TXM+) - I8-10 (TXM-)
    Always
    60 to 80 Ω



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the wiring diagram below, check the AVC-LAN circuit between the radio receiver assembly and the component shown by the sub-code.

    1. Disconnect all connectors between the television display assembly and the component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component shown by the sub-code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

END