CAN COMMUNICATION SYSTEM > 4WD Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| 4WD Control ECU Communication Stop Mode | Either condition is met:
|
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (4WD CONTROL ECU CAN BRANCH WIRE) |
![]() |
Disconnect the A28 4 wheel drive control ECU (4WD control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A28-19 (CANH) - A28-20 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to 4 Wheel Drive Control ECU [4WD Control ECU]) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (4WD CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Disconnect the A29 4 wheel drive control ECU (4WD control ECU) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A29-3 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A29-4 (GND) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to 4 Wheel Drive Control ECU [4WD Control ECU]) |
|
| ||||
| OK | ||
| ||