Home › Suspension › REAR SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > INSTALLATION

for Preparation Click here



1. INSTALL REAR COIL SPRING LH
  1. Using SST, compress the coil spring.

    SST
    09727-30021  



  1. Fit the coil spring to the No. 2 lower arm, and jack up the No. 2 lower arm. Install the coil spring as shown in the illustration.


    C206454E01



    C181307E01
  1. Confirm that the ID mark on the rear coil spring is visible through the drain hole of the No. 2 lower arm.

    NOTICE:
    If the ID mark is not visible, reinstall the coil spring.

  1. Remove the SST from the coil spring.



2. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH
  1. Tighten the 3 bolts and 3 nuts.

    Torque:
    185 N*m{ 1886 kgf*cm , 137 ft.*lbf }



3. INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
(Click here)


4. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)