REAR SHOCK ABSORBER > INSTALLATION |
| 1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY (w/o Air Suspension) |
Temporarily install the upper side of the shock absorber to the chassis frame with the bolt and nut.
Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt.
| 2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY (w/ Air Suspension) |
Temporarily install the upper side of the shock absorber to the chassis frame with the bolt and nut.
Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt.
Connect the AVS connector.
| 3. INSTALL REAR STABILIZER BAR |
| 4. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Air Suspension) |
![]() |
Install the rear height control sensor with the nut.
Connect the rear height control sensor connector.
![]() |
Align the matchmark on the rear height control sensor link and bracket.
Install the rear height control sensor link with the nut.
| 5. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD) |
| 6. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD) |
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Align the matchmarks on the propeller shaft flange and transfer flange.
Install the propeller shaft assembly with the 8 nuts.
| 7. INSTALL TRANSFER HEAT INSULATOR (for 4WD) |
![]() |
Install the transfer heat insulator with the 3 bolts.
| 8. INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Install the propeller shaft heat insulator with the 2 bolts.
| 9. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FE) |
Connect the tailpipe to the exhaust pipe support.
![]() |
Install a new gasket to the center exhaust pipe.
Connect the tailpipe to the center exhaust pipe.
Attach a new clamp to the tailpipe and center exhaust pipe. Then install the bolt to the clamp.
| 10. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FBE) |
Connect the tailpipe to the exhaust pipe support.
![]() |
Install a new gasket to the center exhaust pipe.
Connect the tailpipe to the center exhaust pipe.
Attach a new clamp to the tailpipe and center exhaust pipe. Then install the bolt to the clamp.
| 11. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 1UR-FE) |
![]() |
Connect the tailpipe to the exhaust pipe support.
![]() |
Install a new gasket to the center exhaust pipe.
Connect the tailpipe to the center exhaust pipe.
Attach a new clamp to the tailpipe and center exhaust pipe. Then install the bolt to the clamp.
| 12. INSTALL REAR WHEEL |
| 13. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 14. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY |
![]() |
Tighten the 2 bolts and nut.
| 15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |