Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Blind spot monitor system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair.


CHECK DLC3
  1. Check the DLC3 (Click here).


DIAGNOSIS FUNCTION
  1. The blind spot monitor system displays the blind spot monitor system warning on the multi-information display in the combination meter assembly to inform the driver that the system is unavailable either temporarily, or unavailable due to a malfunction.


MALFUNCTION HISTORY

HINT:
The malfunction history for the blind spot monitor sensor can be displayed and cleared.

  1. Confirm the malfunction history.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream on.

    4. Turn the blind spot monitor main switch (warning canceling assembly) on.

    5. Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History

    6. Confirm the displayed malfunction history results.

      HINT:
      1. If "YES" is displayed, perform the inspections listed under "Inspection Procedure" for each item.
      2. If "NO" is displayed, proceed to the next suspected area in the problem symptoms table (Click here).


      Malfunction History Chart 
      Item
      Description
      Inspection Procedure
      History of Module Blockage
      History of instances in which blind spot monitor sensor could not perform detection properly due to snow on rear bumper, rain, etc.
      1. Check whether a Toyota genuine bumper is installed
      2. Check that there is no foreign matter adhering to the bumper
      3. Check that there is no foreign matter between the sensor and the bumper
      History of Low Voltage
      History of low supply voltage from battery to blind spot monitor sensor
      Power source circuit (Click here)
      History of High Voltage
      History of high supply voltage from battery to blind spot monitor sensor
      History of Low Temperature
      History of low temperature for the blind spot monitor sensor
      Check the outside temperature
      History of High Temperature
      History of high temperature for the blind spot monitor sensor

  2. Clear the malfunction history.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream on.

    4. Turn the blind spot monitor main switch (warning canceling assembly) on.

    5. Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History

    6. Clear the BSM Master Abnormal History.