FUEL INJECTOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the fuel pump ECU connector (Click here).
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch off.
Crank the engine again, and then check that the engine does not start.
Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.
Connect the fuel pump ECU connector (Click here).
| 2. REMOVE V-BANK COVER |
![]() |
Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose from the air cleaner hose assembly.
Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.
Loosen the 2 hose clamps.
Remove the air cleaner hose assembly.
| 4. DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the No. 2 fuel tube from the fuel pressure regulator (for quick type A) (Click here).
| 5. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the fuel tube from the fuel delivery pipe (for quick type A) (Click here).
![]() |
Disconnect the fuel tube from the No. 2 fuel delivery pipe (for quick type A) (Click here).
| 6. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Detach the clamp.
Disconnect the No. 1 fuel pipe from the No. 2 fuel delivery pipe (for quick type B) (Click here).
| 7. DISCONNECT NO. 3 VENTILATION HOSE |
![]() |
Disconnect the No. 3 ventilation hose and No. 6 wire harness connector.
| 8. REMOVE NO. 3 ENGINE COVER |
Remove the No. 3 engine cover.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and fuel delivery pipe.
Remove the 2 spacers and 4 insulators from the cylinder head RH.
| 10. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
Remove the No. 1 engine cover.
| 11. REMOVE NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY |
Disconnect the No. 7 wire harness connector.
![]() |
Remove the 2 bolts and No. 2 fuel delivery pipe.
Remove the 2 spacers and 4 insulators from the cylinder head LH.
| 12. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Remove the fuel injector from the fuel delivery pipe, and then disconnect the injector connector.
![]() |
![]() |
Remove the O-ring from the fuel injector.