WIPER AND WASHER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the LIN Communication System is functioning normally.
| Result | Proceed to |
| LIN DTC is not output | A |
| LIN DTC is output | B |
|
| ||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 6.REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|