DTC P0418 Secondary Air Injection System Control "A" Circuit |
DTC P0419 Secondary Air Injection System Control "B" Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0418 P0419 |
|
|
| P0418 P0419 |
|
|
| AID Diagnostic Signal Waveform | ECM Command | DTC (ECM Output) | Suspected Trouble Area |
100% Duty Ratio![]() | Any Secondary Air Injection (AIR) System operation | P1613 P1614 |
|
0% Duty Ratio![]() | AIR System: ON (Air pump ON, ASV ON) | P1613 P1614 |
|
| AIR System: OFF (Air pump OFF, ASV OFF) | - | Normal | |
20% Duty Ratio![]() | Air Pump: ON | P0418 P0419 |
|
| Air Pump: OFF | P0418 P0419 |
| |
40% Duty Ratio![]() | ASV: ON | P0412 P0415 |
|
| ASV: OFF | P0412 P0415 |
| |
80% Duty Ratio![]() | AIR System: OFF (Air pump OFF, ASV OFF) | P1613 P1614 |
|
| AIR System: ON (Air pump ON, ASV ON) | - | Normal | |
| Other than above (other than 0, 20, 40, 80 and 100% duty) | - | P1613 P1614 |
|
| 1.CHECK HARNESS AND CONNECTOR (AIR PUMP - BODY GROUND) |
![]() |
Disconnect the air pump connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D35-1 - Body ground | Always | Below 1 Ω |
| D36-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR PUMP - AIR INJECTION CONTROL DRIVER) |
![]() |
Disconnect the air pump connector.
Disconnect the AID connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D35-2 - D31-2 (VP) | Always | Below 1 Ω |
| D36-2 - D33-2 (VP2) | Always | Below 1 Ω |
| D35-2 or D31-2 (VP) - Body ground | Always | 10 kΩ or higher |
| D36-2 or D33-2 (VP2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT AIR INJECTION CONTROL DRIVER |
Start the engine and warm it up.
Turn the ignition switch off.
Replace the air injection control driver with normal ones from another vehicle.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Clear DTCs (if set) (Click here).
Enter the following menus: Powertrain / Engine and ECT / Utility / Air Injection Check / Automatic Mode.
Start the engine after the intelligent tester initialization is finished.
Perform the System Check operation by pressing ENTER (Next).
After operating the AIR system, perform the following to confirm the AIR system pending codes: Press the Exit button.
Check pending DTCs.
| Result | Proceed to |
| P0418 and/or P0419 are output | A |
| No pending DTC is output | B |
Turn the ignition switch off.
|
| ||||
| A | ||
| ||