DTC B1788 Rear Occupant Classification Sensor RH Collision Detection |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1788 | Either of following conditions is met:
|
|

| 1.CHECK FOR DTCs |
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear any DTCs stored in the center airbag sensor (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, check for DTCs of the occupant classification ECU (Click here).
|
| ||||
| OK | ||
| ||
| 2.PERFORM ZERO POINT CALIBRATION |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, perform the zero point calibration (Click here).
|
| ||||
| OK | |
| 3.PERFORM SENSITIVITY CHECK |
Using the intelligent tester, perform the sensitivity check (Click here).
|
| ||||
| OK | |
| 4.CHECK FOR DTCs |
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in the center airbag sensor (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, check for DTCs of the occupant classification ECU (Click here).
|
| ||||
| OK | ||
| ||
| 5.REPLACE FRONT SEAT ASSEMBLY RH |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Replace the front seat frame with adjuster RH.
| NEXT | |
| 6.PERFORM ZERO POINT CALIBRATION |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, perform the zero point calibration (Click here).
|
| ||||
| OK | |
| 7.PERFORM SENSITIVITY CHECK |
Using the intelligent tester, perform the sensitivity check (Click here).
|
| ||||
| OK | |
| 8.CHECK FOR DTCs |
Connect the connectors to the occupant classification ECU and the rear occupant detection sensor RH.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear any DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, check for DTCs of the occupant classification ECU (Click here).
|
| ||||
| OK | ||
| ||
| 9.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 10.PERFORM ZERO POINT CALIBRATION |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Using the intelligent tester, perform the zero point calibration (Click here).
| NEXT | |
| 11.PERFORM SENSITIVITY CHECK |
Using the intelligent tester, perform the sensitivity check (Click here).
| NEXT | ||
| ||