Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/ AVS)

DTC    C1784    Steering Angle Sensor Communication Error

for Preparation Click here


DESCRIPTION

The steering angle sensor signal is sent to the suspension control ECU through the CAN communication system. When there is a communication malfunction, this DTC is stored by the diagnosis function.

DTC Code
Detection Condition
Trouble Area
C1784
A steering angle sensor or steering angle sensor power source malfunction signal is detected for 5 seconds or more.
  1. Steering angle sensor
  2. Steering angle sensor power source circuit
  3. Suspension control ECU

WIRING DIAGRAM


C214176E07


INSPECTION PROCEDURE

NOTICE:
  1. After replacing the suspension control ECU, perform registration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
If DTC C1782 is output at the same time as C1784, perform troubleshooting for C1782 first (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check if DTCs C1784 and U0126 are output (Click here).
    Result 
    Condition
    Proceed to
    DTC is not output or only DTC C1784 is output
    A
    DTCs C1784 and U0126 are output
    B



B
GO TO DTC U0126 (Click here)
A


2.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for steering angle sensor malfunction DTCs (Click here).
    Result 
    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


3.CHECK TERMINAL VOLTAGE AND RESISTANCE (IG, BAT, ESS)
  1. Disconnect the H6 steering angle sensor connector.



    C241575E02
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H6-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    H6-3 (BAT) - Body ground
    Always
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H6-2 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Check that the steering angle sensor connector is not deformed or corroded.

    OK:
    No deformation or corrosion.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.READ VALUE USING INTELLIGENT TESTER (STEERING ANGLE)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / Air suspension / Data List.

    Air Suspension 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Steering Angle
    Steering angle sensor reading/
    Min.: -49152.0 deg
    Max.: 49150.5 deg
    Actual steering angle
    Left turn: reading increases
    Right turn: reading decreases
    -

    OK:
    Steering wheel turning angle value changes when steering wheel is turned.



NG
REPLACE STEERING ANGLE SENSOR (Click here)
OK

REPLACE SUSPENSION CONTROL ECU (Click here)