DTC U0208 Lost Communication with "Seat Control Module A" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0208 | There is no communication from the front power seat switch LH (power seat control ECU). |
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the CAN main wire or CAN branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT SWITCH LH CAN BRANCH WIRE) |
![]() |
Disconnect the X11 front power seat switch LH (power seat control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| X11-5 (CANH) - X11-1 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Front Power Seat Switch LH [Power Seat Control ECU]) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Disconnect the X10 front power seat switch LH (power seat control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| X10-1 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| X10-5 (+B) - Body ground | Always | 11 to 14 V |
| X11-8 (SYSB) - Body ground | Always | 11 to 14 V |
| X11-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Front Power Seat Switch LH [Power Seat Control ECU]) |
|
| ||||
| OK | ||
| ||