CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Read the precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the roof headlining (Click here).
![]() |
Install SST.
Disconnect the connector from the curtain shield airbag.
After connecting SST to each other, connect them to the curtain shield airbag.
![]() |
Move SST at least 10 m (32.8 ft.) away from the vehicle rear side window.
Maintaining enough clearance for SST wire harness in the rear side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the battery positive (+) terminal and black clip of SST to the battery negative (-) terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Press SST activation switch and deploy the airbag.
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Remove the curtain shield airbag (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag.
![]() |
Using a service-purpose wire harness for the vehicle, tie down the curtain shield airbag to the tire.
![]() |
Position the curtain shield airbag inside the tire as shown in the illustration.
Tie the curtain shield airbag to the tire with several wire harnesses.
Install SST.
After connecting SST to each other, connect them to the curtain shield airbag.
![]() |
Place the tires.
Place at least 2 tires under the tire which the curtain shield airbag is tied to.
![]() |
Place at least 2 tires over the tire which the curtain shield airbag is tied to. The top tire should have the disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
![]() |
Install SST.
Connect SST connector.
Deploy the airbag.
Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.
Check that no one is within a 10 m (32.8 ft.) radius of the tire which the curtain shield airbag is tied to.
Press SST activation switch and deploy the airbag.
![]() |
Dispose of the curtain shield airbag.
Remove the curtain shield airbag from the tire.
Place the curtain shield airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.