Home › Engine / Hybrid System › 3UR-FE EMISSION CONTROL › AIR SWITCHING VALVE (w/ Secondary Air Injection System)

AIR SWITCHING VALVE (w/ Secondary Air Injection System) > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY
  1. Remove the exhaust manifold (Click here).



2. REMOVE INTAKE MANIFOLD
  1. Remove the intake manifold (Click here).



3. REMOVE INLET RADIATOR HOSE


    A183232
  1. Remove the inlet radiator hose.



4. DISCONNECT OUTLET RADIATOR HOSE


    A183247
  1. Disconnect the outlet radiator hose from the water inlet housing.



5. REMOVE FAN SHROUD


    A151842
  1. Loosen the 4 nuts holding the fluid coupling and fan.

  1. Remove the fan and generator V belt .



    A161784
  1. Detach the claw to open the No. 1 flexible hose clamp.



    A183235
  1. Disconnect the reservoir hose from the upper radiator tank.

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the fan bracket.



6. DISCONNECT NO. 1 WATER BY-PASS HOSE


    A158577E01
  1. Disconnect the No. 1 water by-pass hose from the water by-pass joint and water inlet housing.



7. DISCONNECT NO. 2 WATER BY-PASS HOSE
  1. Disconnect the No. 2 water by-pass hose from the water by-pass joint.



8. DISCONNECT WATER BY-PASS PIPE HOSE


    A158578
  1. Remove the 3 bolts and disconnect the water by-pass pipe hose.



9. REMOVE NO. 2 CYLINDER HEAD COVER


A158576
  1. Remove the No. 2 cylinder head cover.



10. DISCONNECT FUEL TUBE CLAMP


    A158580
  1. Disconnect the fuel tube clamp from the bracket.



11. REMOVE NO. 1 ENGINE COVER


A158581
  1. Remove the No. 1 engine cover.



12. REMOVE FRONT WATER BY-PASS JOINT
  1. Disconnect the engine coolant temperature sensor connector.



    A158579
  1. Remove the 4 nuts, front water by-pass joint and 2 gaskets.



13. REMOVE AIR PIPE SUB-ASSEMBLY


    A158575
  1. Disconnect the No. 2 air injection system hose and No. 3 air injection system hose.

  1. Disconnect the electric air control valve connector.

  1. Disconnect the electric air control valve connector clamp holder.

  1. Using a clip remover, detach the wire harness claw.



    A158582
  1. Remove the 2 bolts and air pipe.

  1. Disconnect the 2 No. 1 air hoses from the electric air control valve assembly.



14. REMOVE ELECTRIC AIR CONTROL VALVE ASSEMBLY


    A158583
  1. Disconnect the knock sensor connector.

  1. Remove the bolt and bracket.

  1. Disconnect the 2 electric air control valve connectors.



    A158586
  1. Remove the 3 bolts and electric air control valve assembly.



15. REMOVE NO. 2 AIR TUBE


    A158584
  1. Remove the 2 bolts, No. 2 air tube and gasket.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



16. REMOVE NO. 3 AIR TUBE


    A158585
  1. Remove the 2 bolts, No. 3 air tube and gasket.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.