Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL REAR STABILIZER BUSH
  1. Install the 2 bushes to the outer side of the bush stoppers on the rear stabilizer bar.

    HINT:
    Install the bush so that the cutout faces the rear of the vehicle.



2. TEMPORARILY INSTALL REAR STABILIZER BAR
  1. Temporarily install the rear stabilizer bar with the 4 bolts.



3. TIGHTEN REAR STABILIZER BRACKET


C180768E01
  1. Install the rear stabilizer bar with the 4 bolts.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }



4. TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY LH


C180603
  1. Temporarily install the rear stabilizer link with the 2 nuts.



5. TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



6. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD)
(Click here)


7. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD)
(Click here)


8. INSTALL TAILPIPE ASSEMBLY
  1. Connect the tailpipe assembly to the 2 exhaust pipe supports.



    A207210E01
  1. Install a new gasket to the center exhaust pipe assembly.

  1. Connect the tailpipe to the center exhaust pipe assembly.

  1. Attach a new clamp to the tailpipe assembly and center exhaust pipe assembly. Then install the bolt to the clamp.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    HINT:
    Install the clamp so that it is positioned as shown in the illustration.



9. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



10. TIGHTEN REAR STABILIZER LINK ASSEMBLY LH
  1. Install the rear stabilizer link with the 2 nuts.

    Torque:
    98 N*m{ 999 kgf*cm , 72 ft.*lbf }



11. TIGHTEN REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.