Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/ AVS)

DTC    C1791    Absorber Control Switch Circuit (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The absorber control switch is used to select the damping force mode of the shock absorber.

DTC Code
Detection Condition
Trouble Area
C1791
Absorber control switch signal does not change.
  1. Absorber control switch
  2. Wire harness or connector
  3. Suspension control ECU

HINT:
This DTC is output only when the sensor signal check is done.


WIRING DIAGRAM


C179524E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (ABSORBER CONTROL SWITCH)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON, and turn the intelligent tester on.

  1. Enter the following menus: Chassis / Air suspension / Data List.

    Air Suspension 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    COMFORT Switch
    Absorber control switch (COMFORT) / ON or OFF
    ON: COMFORT
    OFF: Normal
    -
    SPORT Switch
    Absorber control switch (SPORT) / ON or OFF
    ON: SPORT
    OFF: Normal
    -

  1. Check that the value displayed on the intelligent tester changes by operating the absorber control switch "COMFORT" or "SPORT".

    OK:
    Absorber control switch value changes.

    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to the Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC Chart)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.INSPECT ABSORBER CONTROL SWITCH


    C179525E01
  1. Turn the ignition switch off.

  1. Remove the absorber control switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (GND) - 8 (ECU1)
    COMFORT position
    Below 1 Ω
    Normal position
    10 kΩ or higher
    7 (GND) - 9 (ECU2)
    SPORT position
    Below 1 Ω
    Normal position
    10 kΩ or higher



NG
REPLACE ABSORBER CONTROL SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (ABSORBER CONTROL SWITCH - ECU AND BODY GROUND)


    C179526E01
  1. Disconnect the O18 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H71-8 (ECU1) - O18-3 (TSW1)
    Always
    Below 1 Ω
    H71-9 (ECU2) - O18-2 (TSW2)
    Always
    Below 1 Ω
    H71-7 (GND) - Body ground
    Always
    Below 1 Ω
    H71-8 (ECU1) or O18-3 (TSW1) - Body ground
    Always
    10 kΩ or higher
    H71-9 (ECU2) or O18-2 (TSW2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU (Click here)