Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type)

REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM


E280619E22


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)


    E300428
  1. Enter the "Function Check/Setting I" mode and select "Vehicle Signal" (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever position.

    OK:
    Shift Lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual shift lever position.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


    E300429E02
  1. Disconnect the radio and display receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I58-2 (REV) - Body ground
    Ignition switch ON, shift lever in R
    7.5 to 14 V
    I58-2 (REV) - Body ground
    Ignition switch ON, shift lever not in R
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio and Display Receiver Assembly)



NG
Go to step 3
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
  1. Disconnect the I58 radio and display receiver assembly connector.

  1. Disconnect the D21 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-2 (REV) - D21-1 (RL)
    Always
    Below 1 Ω
    I58-2 (REV) or D21-1 (RL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY)


    E270424E24
  1. Disconnect the park/neutral position switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D21-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Park/Neutral Position Switch Assembly)
    Result 
    Result
    Proceed to
    OK (for AB60E)
    A
    OK (for AB60F)
    B
    NG
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)