Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB1    Short to +B in Outer Mirror Indicator(Slave)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects a +B short in the blind spot monitor indicator LH.

DTC Code
DTC Detection Condition
Trouble Area
C1AB1
With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage applied to the indicator is high for a certain amount of time even though the blind spot monitor sensor is not outputting voltage to the indicator.
  1. Harness or connector
  2. Blind spot monitor sensor LH
  3. Outer rear view mirror assembly LH
  4. Outer rear view mirror glass LH

WIRING DIAGRAM


E221720E04


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR
  1. Disconnect the O46 blind spot monitor sensor LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O46-6 (OMIL) - Body ground
    Ignition switch ON
    Below 1 V



NG
Go to step 3
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)  

3.CHECK HARNESS AND CONNECTOR
  1. Disconnect the M5 outer rear view mirror assembly LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O46-6 (OMIL) - Body ground
    Ignition switch ON
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR
  1. Disconnect the m5 outer rear view mirror glass LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O46-6 (OMIL) - Body ground
    Ignition switch ON
    Below 1 V



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK

REPLACE OUTER REAR VIEW MIRROR GLASS LH (Click here)