DTC C1AB4 Open in Outer Mirror Indicator(Master) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1AB4 | With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the current flowing to the indicator is below a specified value when indicator operation voltage is sent to the indicator. |
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY RH - BLIND SPOT MONITOR SENSOR RH AND BODY GROUND) |
Disconnect the P25 blind spot monitor sensor RH connector.
Disconnect the L6 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P25-6 (OMIR) - L6-9 (BSR+) | Always | Below 1 Ω |
| L6-5 (LP-) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT BLIND SPOT MONITOR INDICATOR RH |
![]() |
Remove the outer rear view mirror assembly RH (Click here).
Apply battery voltage to the terminal of the outer rear view mirror assembly RH, and check that the blind spot monitor indicator turns on.
| Connection | Specified Condition |
| Battery positive (+) → 9 (BSR+) Battery negative (-) → 5 (LP-) | Indicator turns on |
| *1 | Blind Spot Monitor Indicator RH |
|
| ||||
| OK | ||
| ||
| 4.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH |
![]() |
Remove the outer rear view mirror assembly RH (Click here).
Remove the outer rear view mirror glass RH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 9 (BSR+) - 7 (+) | Always | Below 1 Ω |
| 5 (LP-) - 5 (-) | Always | Below 1 Ω |
| *a | Vehicle Side |
| *b | Outer Rear View Mirror Glass RH Side |
|
| ||||
| OK | ||
| ||