Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U0233    Lost Communication with Blind Spot Monitor Master Module

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor assembly LH judges that there is a communication problem with the blind spot monitor sensor RH.

DTC Code
DTC Detection Condition
Trouble Area
U0233
The blind spot monitor sensor LH cannot receive signals from the blind spot monitor sensor RH.
  1. CAN communication system
  2. Blind spot monitor sensor RH
  3. Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs of the CAN communication system (Click here).

    OK:
    CAN communication system DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.REPLACE BLIND SPOT MONITOR SENSOR RH
  1. Replace the blind spot monitor sensor RH (Click here).


NEXT


3.RECHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
OK

END (BLIND SPOT MONITOR SENSOR RH IS DEFECTIVE)