Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM27L0U _51 Engine / Hybrid System _049294 3UR-FE ENGINE CONTROL _0235541 AIR FUEL RATIO SENSOR A

3UR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 17450B 1.REMOVE FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

a.

Disconnect the air fuel ratio sensor connector.


b.

Disconnect the heated oxygen sensor connector and 2 clamps.


c.
A184985

Remove the 2 bolts and 2 nuts from the center exhaust pipe assembly.


d.

Remove the 3 nuts, 2 gaskets and front No. 2 exhaust pipe sub-assembly.


Hide 89465 3.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A194684E02
1.99,1.073 2.615,1.073 false 2.688,0.979 3.042,1.188 0.354,0.208 10 false SST

Using SST, remove the air fuel ratio sensor.

SST
09224-00010  


Hide 4.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.
A194684E02
1.99,1.073 2.615,1.073 false 2.688,0.979 3.042,1.188 0.354,0.208 10 false SST

Using SST, remove the air fuel ratio sensor.

SST
09224-00010