Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM27L0U _51 Engine / Hybrid System _049294 3UR-FE ENGINE CONTROL _0235546 POWER STEERING OIL PRESSURE SWITCH G

3UR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438A 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the oil pressure switch.

i.

Connect the Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the Techstream main switch on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering Pressure.


v.

Start the engine.


vi.

Operate the steering wheel while idling, and read the value on the Techstream.

Standard:
Condition Specified Condition
Power steering not operating 0 to 2 MPa
Power steering operating Values change from above value


If not as specified, check for DTCs (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

Inspect the power steering system (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>ON-VEHICLE INSPECTION). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.