11301C
1.INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
Apply MP grease to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge.
Keep the lip free from foreign matter.
Do not tap the oil seal at an angle.
13521A
2.INSTALL CRANKSHAFT TIMING GEAR KEY
Install the crankshaft timing gear key.
13471
3.INSTALL CRANKSHAFT PULLEY
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
Using SST, install the pulley set bolt.
48811
4.INSTALL FRONT STABILIZER BAR
Install the stabilizer bar and 2 stabilizer bushes and 2 stabilizer brackets with the 4 bolts.
16400
5.INSTALL RADIATOR ASSEMBLY
Install the radiator assembly (See page Engine / Hybrid System>3UR-FBE COOLING>RADIATOR>INSTALLATION).
6.INSPECT FOR OIL LEAK