Home › Engine / Hybrid System › 3UR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM27L0U _51 Engine / Hybrid System _049296 3UR-FE ENGINE MECHANICAL _0235564 FRONT CRANKSHAFT OIL SEAL A

3UR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.


b.
A163995E09
1.771,2.635 1.854,3.01 false 1.854,3.01 1.927,2.604 false 1.688,3.031 2.01,3.208 0.323,0.177 10 true SST

Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge.

SST
09223-22010  
09506-35010  

NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap the oil seal at an angle.




Hide 13521A 2.INSTALL CRANKSHAFT TIMING GEAR KEY

a.
A163993

Install the crankshaft timing gear key.


Hide 13471 3.INSTALL CRANKSHAFT PULLEY

a.

Align the pulley set key with the key groove of the pulley, and slide on the pulley.


b.
A164230E01
0.179,0.579 0.528,0.750 0.349,0.172 10 Hold 0.626,1.567 0.969,1.751 0.343,0.184 10 Turn 2.353,1.713 2.683,1.904 0.330,0.191 10 SST 2.032,1.329 2.322,1.787 false 2.322,1.787 1.814,1.441 false

Using SST, install the pulley set bolt.

SST
09213-70011  
09330-00021  

Torque:
300 N*m (3059 kgf*cm, 221 ft.*lbf)


Hide 48811 4.INSTALL FRONT STABILIZER BAR

a.
A163793

Install the stabilizer bar and 2 stabilizer bushes and 2 stabilizer brackets with the 4 bolts.

Torque:
69 N*m (704 kgf*cm, 51 ft.*lbf)


Hide 16400 5.INSTALL RADIATOR ASSEMBLY

a.

Install the radiator assembly (See page Engine / Hybrid System>3UR-FE COOLING>RADIATOR>INSTALLATION).


Hide 6.INSPECT FOR OIL LEAK