16572
1.INSTALL OUTLET RADIATOR HOSE
Install the outlet radiator hose into the radiator.
Install the hose so that the direction of the hose clamp is as indicated in the illustration.
16400
2.INSTALL RADIATOR ASSEMBLY
Set the radiator bracket hooks to the radiator support holes.
Install the radiator with the 4 bolts.
16561
3.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL (for LH Side)
Install the No. 1 radiator to support seal with the 3 clips.
16561
4.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL (for RH Side)
Install the No. 1 radiator to support seal with the 3 clips.
53294C
5.INSTALL RADIATOR SIDE DEFLECTOR LH
Install the deflector with the 6 clips.
Connect the wire harness clamp.
53293C
6.INSTALL RADIATOR SIDE DEFLECTOR RH
Install the deflector with the 6 clips.
16711
7.INSTALL FAN SHROUD
Install the fan pulley to the fan bracket.
Place the shroud together with the coupling fan between the radiator and engine.
Be careful not to damage the radiator core.
Temporarily install the fluid coupling fan to the fan bracket with the 4 nuts. Tighten the nuts as much as possible by hand.
Attach the shroud claws to the radiator as shown in the illustration.
Install the shroud with the 2 bolts.
Connect the reservoir hose to the upper radiator tank.
Install the fan and generator V belt (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).
Tighten the 4 nuts of the fluid coupling fan.
16571
8.INSTALL INLET RADIATOR HOSE
Install the inlet radiator hose.
Install the hose so that the direction of the hose clamp is as indicated in the illustration.
16572
9.CONNECT OUTLET RADIATOR HOSE
Connect the outlet radiator hose to the water inlet housing.
10.ADD ENGINE COOLANT
11.INSPECT FOR COOLANT LEAK
52119A
12.INSTALL FRONT BUMPER COVER ASSEMBLY
Install the front bumper cover assembly (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION).
51441
13.INSTALL NO. 1 ENGINE UNDER COVER
11209
14.INSTALL V-BANK COVER SUB-ASSEMBLY