16400
1.REMOVE RADIATOR ASSEMBLY
Remove the radiator assembly (See page Engine / Hybrid System>3UR-FE COOLING>RADIATOR>REMOVAL).
48811
2.SEPARATE FRONT STABILIZER BAR
Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes, separate the stabilizer bar.
13471
3.REMOVE CRANKSHAFT PULLEY
Using SST, loosen the crankshaft pulley set bolt.
Partially install the pulley set bolt to the crankshaft until 2 or 3 threads are engaged.
Using the pulley set bolt and SST, remove the crankshaft pulley.
13521A
4.REMOVE CRANKSHAFT TIMING GEAR KEY
Remove the crankshaft timing gear key from the crankshaft.
11301C
5.REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
Using a screwdriver, pry out the oil seal.
Tape the screwdriver tip before use.
Do not damage the surface of the oil seal press fit hole and crankshaft.