51441
1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
52119A
3.REMOVE FRONT BUMPER COVER ASSEMBLY
Remove the front bumper cover assembly (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL).
11209
4.REMOVE V-BANK COVER SUB-ASSEMBLY
16571
5.REMOVE INLET RADIATOR HOSE
Remove the inlet radiator hose.
16572
6.DISCONNECT OUTLET RADIATOR HOSE
Disconnect the outlet radiator hose from the water inlet housing.
16711
7.REMOVE FAN SHROUD
Loosen the 4 nuts holding the fluid coupling and fan.
Remove the fan and generator V belt (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL).
Disconnect the reservoir hose from the upper radiator tank.
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Be careful not to damage the radiator core.
Remove the fan pulley from the fan bracket.
53293C
8.REMOVE RADIATOR SIDE DEFLECTOR RH
Remove the 6 clips and side deflector.
53294C
9.REMOVE RADIATOR SIDE DEFLECTOR LH
Remove the 6 clips and side deflector.
Disconnect the wire harness clamp.
16561
10.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL (for LH Side)
Remove the 3 clips and remove the No. 1 radiator to support seal.
16561
11.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL (for RH Side)
Remove the 3 clips and remove the No. 1 radiator to support seal.
16400
12.REMOVE RADIATOR ASSEMBLY
Remove the 4 bolts and radiator.
16572
13.REMOVE OUTLET RADIATOR HOSE
Remove the outlet radiator hose from the radiator.