Home › Engine / Hybrid System › 3UR-FBE FUEL › FUEL PRESSURE SWITCHING VALVE
RM27L0U _51 Engine / Hybrid System _049297 3UR-FBE FUEL _0235576 FUEL PRESSURE SWITCHING VALVE A

3UR-FBE FUEL  FUEL PRESSURE SWITCHING VALVE  REMOVAL  


PROCEDURE

Hide 77100 1.REMOVE FUEL TANK ASSEMBLY

a.

Hide 77266A 2.REMOVE NO. 1 FUEL TUBE PROTECTOR

a.
A194672

Remove the nut and No. 1 fuel tube protector.


Hide 3.REMOVE FUEL PRESSURE SWITCHING VALVE ASSEMBLY

a.
A196281E03
0.24,3.635 0.281,3.115 0.281,3.115 0.51,3.115 false 0.698,3.49 1.156,3.26 1.156,3.26 1.51,3.26 true 2.573,4.052 2.573,4.167 false 0.594,4.208 0.594,4.375 false 1.094,3.979 1.094,4.26 1.094,4.26 1.479,4.26 false 1.323,3.979 1.323,4.25 false 2.458,1.938 3.135,2.125 0.677,0.188 10 false Lifting up 0.542,3.042 0.906,3.25 0.365,0.208 10 false Pipe 1.552,3.177 2.198,3.396 0.646,0.219 10 false Retainer 0.219,4.396 0.948,4.583 0.729,0.188 10 false Connector 1.521,4.188 2.073,4.385 0.552,0.198 10 false O-Ring 2.229,4.188 3.021,4.406 0.792,0.219 10 false Nylon Tube

Disconnect the 3 fuel tank main tubes and remove the fuel pressure switching valve.

i.

Detach the lock claws by lifting up the cover, as shown in the illustration.


ii.

Pinch and pull the fuel tank main tube connector to disconnect the main tube connector from the pipe.

NOTICE:
·

Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.

·

Do not use any tools to separate the pipe and connector.

·

Do not forcefully bend or twist the nylon tube.

·

Check for foreign matter on the pipe seal surface. Clean if necessary.

·

Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.

·

If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.