Home › Engine / Hybrid System › 3UR-FE FUEL › FUEL INJECTOR
RM27L0U _51 Engine / Hybrid System _049298 3UR-FE FUEL _0235578 FUEL INJECTOR G

3UR-FE FUEL  FUEL INJECTOR  INSPECTION  


PROCEDURE

Hide 23250 1.INSPECT FUEL INJECTOR ASSEMBLY

a.

Inspect the injection volume.

CAUTION:

This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area, and avoid any sparks or flames. Do not smoke.


i.
A380110E02
1.229,0.875 1.073,0.198 1.073,0.198 0.938,0.198 false 0.719,0.104 0.969,0.49 0.25,0.385 10 false *1

Remove the fuel pipe clamp.

Text in Illustration
*1 Fuel Pipe Clamp


ii.

Disconnect the No. 1 fuel pipe sub-assembly (See page Engine / Hybrid System>3UR-FE FUEL>FUEL SYSTEM>PRECAUTION).


iii.
A273854E04
3.083,0.708 3.083,1 false 0.802,0.448 0.635,0.448 0.635,0.448 0.292,1.417 false 0.792,1.563 0.792,1.802 false 2.052,1.521 1.917,1.521 1.917,1.521 1.677,1.26 false 2.958,1.01 3.125,1.177 0.167,0.167 10 false *4 2.083,1.438 2.385,1.594 0.302,0.156 10 false SST 0.844,0.375 1.146,0.521 0.302,0.146 10 false SST 1.208,0.354 1.469,0.531 0.26,0.177 10 false (*1) 2.438,1.406 2.698,1.583 0.26,0.177 10 false (*3) 0.615,1.833 0.917,1.99 0.302,0.156 10 false SST 0.969,1.823 1.229,2 0.26,0.177 10 false (*2)

Connect SST to the fuel pipe (the vehicle side).

SST
09268-31014  (09268-41500, 09268-41700, 95336-08070)

Text in Illustration
*1 Hose
*2 Hose Band
*3 Fuel Tube Connector
*4 Fuel Pipe


iv.
A273855E02
0.7,0.176 1.016,0.356 0.316,0.180 10 SST 2.551,1.401 2.860,1.549 0.309,0.149 10 SST 0.989,1.14 1.167,1.320 0.178,0.180 10 *4 0.881,1.793 1.060,1.973 0.179,0.180 10 *5 0.702,0.716 1.011,0.896 0.309,0.180 10 SST 2.53,1.483 2.338,1.483 false 1.597,0.261 1.383,0.261 false 1.587,0.797 1.383,0.797 false 1.617,1.224 1.189,1.224 false 1.074,0.163 1.331,0.343 0.257,0.180 10 (*1) 2.909,1.38 3.166,1.560 0.257,0.180 10 (*3) 1.071,0.692 1.328,0.872 0.257,0.180 10 (*2) 1.084,1.878 1.286,1.878 1.286,1.878 1.6,2.067 false

Install the O-ring to the fuel injector.


v.

Install SST and the tube to the fuel injector.

SST
09268-31014  (09268-41300, 09268-41500, 09268-41600, 09268-41700)

Text in Illustration
*1 Hose Band
*2 Adapter
*3 Clamp
*4 O-Ring
*5 Tube


vi.
A273857E02
2.826,0.872 3.029,1.058 0.202,0.186 10 *a 2.795,0.959 2.584,0.959 2.584,0.959 2.447,0.8 false 0.532,0.286 1.110,0.486 0.578,0.200 10 SST (*1) 1.233,0.379 1.368,0.379 1.368,0.379 1.588,1.505 false

Pass SST (tie band) through the loop on the handle of SST (clamp) to secure SST (clamp) to SST (adapter).

SST
09268-31014  (09268-41800)

Text in Illustration
*1 Tie Band
*a Lock

NOTICE:
·

As SST (tie band) does not completely prevent SST (clamp) from becoming loose, do not subject the parts to any impacts while using them.

·

Before using SST (tie band), make sure that there is no deterioration, damage or cracks. If there are any abnormalities, replace SST.



HINT:

When removing SST (tie band), disengage the lock.



vii.

Check that SST (clamp) and SST (adapter) cannot be easily separated.


viii.
A273856E05
1.917,0.469 1.917,0.813 false 1.75,0.823 2.063,0.969 0.313,0.146 10 false SST 1.781,1.01 2.042,1.188 0.26,0.177 10 false (*1)

Put the injector into a graduated cylinder.

Text in Illustration
*1 Wire

CAUTION:

Install a strong rubber tube onto the injector to prevent gasoline from splashing.



ix.

Operate the fuel pump (turn the ignition switch to ON).


x.

Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

SST
09842-30090  

Standard injection volume:

83 to 99 cm3 (5.0 to 6.0 cu in.) per 15 seconds


Difference between each injector:

16 cm3 (1.0 cu in.) or less


NOTICE:
·

Make sure that SST (EFI inspection wire I) is securely connected.


·

Always turn the voltage on and off on the battery side, not the fuel pump side.



If the injection volume is not as specified, replace the injector assembly.



b.

Check for leakage.

i.
A149194

In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector.

Standard fuel drop:

1 drop or less in 12 minutes