Home › Engine / Hybrid System › 3UR-FE INTAKE / EXHAUST › VACUUM SWITCHING VALVE
RM27L0U _51 Engine / Hybrid System _049301 3UR-FE INTAKE / EXHAUST _0235603 VACUUM SWITCHING VALVE G

3UR-FE INTAKE / EXHAUST  VACUUM SWITCHING VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17650 2.INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

a.

Disconnect the vacuum switching valve connector.


b.
A162110E09
1.021,4.219 1.26,4.219 false 0.729,1.031 1.052,0.854 false 0.802,2.771 1.01,3.01 false 0.708,0.646 0.969,0.833 false 1.313,4.135 2.229,4.375 0.917,0.24 10 false Body Ground 0.635,0.969 0.74,1.167 0.104,0.198 10 false 1 0.625,0.563 0.729,0.74 0.104,0.177 10 false 2 0.698,2.677 0.802,2.854 0.104,0.177 10 false 2

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 37 to 44 Ω
1 - Body ground Always 1 MΩ or higher
2 - Body ground


If the result is not as specified, replace the vacuum switching valve assembly.


c.

Check the vacuum switching valve operation.

i.
A162111E01
2.037,1.577 2.415,1.733 0.378,0.156 10 Filter 2.197,1.169 2.197,1.555 false 0.576,0.45 1.107,0.592 0.531,0.142 10 Vacuum 1.407,0.805 1.570,0.947 0.163,0.142 10 E 0.932,1.325 1.053,1.481 0.121,0.156 10 F

When applying a vacuum to port E, check that air is sucked into the filter.

If the result is not as specified, replace the vacuum switching valve assembly.


ii.
A162112E01
0.113,1.628 0.641,1.802 0.527,0.173 10 Vacuum 0.767,0.868 0.906,1.007 0.139,0.139 10 E 0.618,1.174 0.742,1.341 0.125,0.166 10 F

Apply voltage across the terminals.


iii.

When applying a vacuum to port F, check that air is sucked into port E.

If the result is not as specified, replace the vacuum switching valve assembly.



d.

Connect the vacuum switching valve connector.