Home › Engine / Hybrid System › 3UR-FBE STARTING › STARTER
RM27L0U _51 Engine / Hybrid System _049308 3UR-FBE STARTING _0235636 STARTER A

3UR-FBE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11452 5.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Remove the dipstick.


b.

Disconnect the wire harness clamp.


c.
A164432

Remove the bolt and dipstick guide.


d.

Remove the O-ring from the dipstick guide.


Hide 58155 7.REMOVE FRONT NO. 3 FLOOR HEAT INSULATOR

Hide 17167 8.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 17104 9.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

Hide 28192 10.REMOVE STARTER COVER

a.
A162756

Remove the 3 bolts and starter cover.


Hide 28100 11.REMOVE STARTER ASSEMBLY

a.
A258301

Detach the 2 wire harness clamps.


b.

Disconnect the starter connector.


c.

Remove the nut and disconnect the starter wire.


d.
A258302

Remove the 2 bolts and starter.


e.
A162758

Remove the flywheel housing side cover.