Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235639 CRUISE CONTROL SYSTEM U

CRUISE CONTROL  CRUISE CONTROL SYSTEM  FAIL-SAFE CHART  


HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.


Vehicle Condition Auto Cancel Condition Re-operation Condition
CRUISE main indicator light blinks
·

There is open or short in stop light switch circuit

·

There is problem with vehicle speed signal


Turn cruise control main switch on again
CRUISE main indicator light blinks
·

There is problem with input circuit of stop light switch circuit

·

There is problem with cancel circuit


Turn ignition switch off then on again
Cruise control is cancelled (The indicator light remains on) At the following conditions, the stored vehicle speed is maintained.
·

Vehicle speed is lower than low speed limit (approx. 40 km/h (25 mph)) while running with cruise control on

·

VSC operates


Push cruise control main switch to + (ACCEL)/RES (RESUME)
Vehicle speed is lower than stored speed by approx. 16 km/h (10 mph) or more Push cruise control main switch to - (COAST)/SET
Cruise control is cancelled (The indicator light is off) There is a problem with throttle position sensor and motor Turn ignition switch off then on again