Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM D

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  OPERATION CHECK  


INPUT SIGNAL CHECK


a.
E117754E07
1.107,0 2.134,0.325 1.028,0.325 10 + (ACCEL)/RES (RESUME) 2.877,0.933 3.320,1.082 0.443,0.149 10 MODE 2.622,2.288 3.190,2.442 0.569,0.154 10 ON-OFF 1.069,2.833 2.061,3.009 0.992,0.177 10 - (COAST)/SET 0.177,2.327 0.766,2.474 0.589,0.147 10 CANCEL

Connect the Techstream to the DLC3.


b.

Check the cruise control main switch using the Data List function in the Techstream (ON-OFF, CANCEL, - (COAST)/SET, + (ACCEL)/RES (RESUME), and MODE).



INSPECT MODE SWITCH


a.
E345246

Turn the ignition switch to ON.


b.
E231515E01
0.256,0.079 1.822,0.255 1.566,0.177 10 Multi-information Display 0.978,2.794 2.808,2.971 1.830,0.177 10 CRUISE Main Indicator Light

Turn the cruise control main switch on. Then push the main switch to MODE for 1 second or more to change to the constant speed control mode. Check that "NORMAL" is indicated on the multi-information display.

NOTICE:

Do not push any other switches before pushing the main switch to MODE. If another switch is pushed, turn the main switch off and repeat the procedure above.


HINT:

If a malfunction is detected, turn the ignition switch off and repeat the procedure above.




INSPECT STEERING PAD SWITCH ASSEMBLY


a.

Turn the ignition switch to ON.


b.

Turn the cruise control main switch on.


c.

Turn on the distance control switch of the steering pad switch.


d.
E286685E01
2.072,0.687 3.142,1.028 1.070,0.342 10 Distance Control Switch 0.131,1.72 1.715,1.874 1.583,0.154 10 Multi-information Display 2.125,2.405 2.637,2.561 0.512,0.156 10 SHORT 2.125,3.263 2.685,3.411 0.560,0.148 10 MIDDLE 2.116,4.14 2.563,4.298 0.446,0.158 10 LONG 2.02,0.772 1.875,0.772 1.875,0.772 1.338,1.163 false

Check that the indication of the vehicle-to-vehicle distance, which is shown on the multi-information display on the combination meter, changes from long to middle to short in that order.

HINT:

The indication is automatically set to long each time the engine is started.