Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM U

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  FAIL-SAFE CHART  


AUTO CANCEL FUNCTION (FAIL-SAFE FUNCTION):


HINT:

If a system malfunction occurs, the applicable DTCs will appear on the multi-information display. In some cases, a DTC will be set due to weather or vehicle operating conditions, this does not indicate a system malfunction.


a.
E230243E01
0.282,0.113 1.841,0.276 1.559,0.163 10 Multi-information Display 0.935,2.811 2.772,2.981 1.836,0.170 10 CRUISE Main Indicator Light

Auto cancel function (in vehicle-to-vehicle distance control mode and constant speed control mode):

The auto cancel function deletes the stored vehicle speed and cancels the cruise control operation when:

i.

The vehicle speed signal malfunctions.


ii.

The electronic throttle parts malfunction.


iii.

The stop light switch has an open or short circuit.


iv.

The brake micro switch circuit is open or short.


v.

Communication lost for skid control ECU to ECM.

If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:

·

The CRUISE main indicator light blinks.

·

The display shows "CHECK CRUISE SYSTEM".


The cruise control operation will be suspended until the main switch is turned on again.



b.
E230243E01
0.282,0.113 1.841,0.276 1.559,0.163 10 Multi-information Display 0.935,2.811 2.772,2.981 1.836,0.170 10 CRUISE Main Indicator Light

Auto cancel function (in vehicle-to-vehicle distance control mode only):

The auto cancel function deletes the stored vehicle speed and cancels the cruise control operation when:

i.

The laser radar sensor malfunctions.


ii.

The light axis of the laser radar sensor deviates.

If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:

·

The CRUISE main indicator light blinks.

·

The display shows "CHECK CRUISE SYSTEM".


The cruise control operation will be suspended until the ignition switch is turned off then on again.



c.
E230242E01
0.245,0.11 1.808,0.285 1.563,0.174 10 Multi-information Display 0.978,2.791 2.792,2.966 1.813,0.174 10 CRUISE Main Indicator Light

Auto cancel function (in vehicle-to-vehicle distance control mode only):

The auto cancel function maintains the stored vehicle speed and cancels the cruise control operation when:

i.

The wiper operates in the HI or LO mode.


ii.

The shift pattern select switch is in the "SNOW" mode.


iii.

The laser radar sensor receives strong light, such as sunlight, from the front side.


iv.

The vehicle-to-vehicle distance measurement is extremely unstable because of bad weather.

If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:

·

The CRUISE main indicator light blinks.

·

The display shows "CRUISE NOT AVAILABLE".


The cruise control operation will be suspended until either the canceling condition is resolved or the main switch is turned on again. When the canceling condition is resolved, it will be possible to resume the vehicle speed set prior to cancellation by pushing the cruise control main switch to + (ACCEL)/RES (RESUME).



d.
E230244E01
0.262,0.093 1.825,0.267 1.563,0.174 10 Multi-information Display 0.953,2.8 2.766,2.974 1.813,0.174 10 CRUISE Main Indicator Light

Auto cancel function (in vehicle-to-vehicle distance control mode only):

The auto cancel function maintains the stored vehicle speed and cancels the cruise control operation when the laser radar sensor has dirt on it.

If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:

·

The CRUISE main indicator light blinks.

·

The display shows "CLEAN RADAR SENSOR".


The cruise control operation will be suspended until either the canceling condition is resolved or the main switch is turned on again. When the canceling condition is resolved, it will be possible to resume the vehicle speed set prior to cancellation by pushing the cruise control main switch to + (ACCEL)/RES (RESUME).


e.
E162191E01
0.903,1.628 2.724,1.765 1.821,0.137 10 CRUISE Main Indicator Light

Other auto cancel function (in vehicle-to-vehicle distance control mode and constant speed control mode):

The auto cancel function maintains the stored vehicle speed and cancels the cruise control operation when:

i.

The vehicle speed drops below approximately 40 km/h (25 mph).


ii.

The shift lever is moved from D to N or the transmission is shifted to the 3rd, 2nd, or 1st gear with the shift lever in S.


iii.

Depressing the brake pedal.


iv.

The VSC operates.

If the auto cancel function operates, the CRUISE main indicator light remains on. The cruise control operation will be suspended until the canceling condition is resolved. When the canceling condition is resolved, it will be possible to resume the vehicle speed set prior to cancellation by pushing the cruise control main switch to + (ACCEL)/RES (RESUME).



f.
E162191E01
0.903,1.628 2.724,1.765 1.821,0.137 10 CRUISE Main Indicator Light

Other auto cancel function (in constant speed control mode only):

The auto cancel function deletes the stored vehicle speed and cancels the cruise control operation when the vehicle speed drops 16 km/h (10 mph) below the stored vehicle speed.

If the auto cancel function operates, the CRUISE main indicator light remains on. The cruise control operation will be suspended until the canceling condition is resolved. When the canceling condition is resolved, it will be possible to set the vehicle speed by pushing the cruise control main switch to - (COAST)/SET.