Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  U0126  Lost Communication with Steering Angle Sensor Module  U1101  Lost Communication with Distance Control ECU  


DESCRIPTION

The ECM communicates several signal with each sensors or ECUs by CAN communication circuit. There are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

DTC No. DTC Detection Condition Trouble Area
U0100 While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a communication cut off signal from the distance control ECU for 0.5 seconds, the ECM records this communication cut off code
·

Communication circuit

·

ECM

·

Distance control ECU


While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a communication cut off signal from the skid control ECU for 1.0 seconds, the ECM records this communication cut off code
·

Communication circuit

·

ECM

·

Skid control ECU


U0122 While dynamic laser cruise control is either preparing for operation or operating, if communication data from the skid control ECU is invalid for a certain amount of time, the ECM records this communication cut off code
·

Communication circuit

·

Skid control ECU

·

ECM


U0126 While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a steering sensor communication error signal for 0.15 seconds, the distance control ECU sends a signal to the ECM to record this trouble code
·

Communication circuit

·

Steering angle sensor

·

Distance control ECU

·

ECM


U1101 While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is invalid for 1.08 seconds, the ECM records this communication cut off code
·

Communication circuit

·

Distance control ECU

·

ECM



CAUTION / NOTICE / HINT

PROCEDURE

1.CHECK FOR DTC
a.

Check for DTC (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0100, U0122, U0126 and U1101 are not output A
DTC U0100, U0122, U0126 or U1101 is output B



A

B