Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235643 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84632 1.INSPECT CRUISE CONTROL MAIN SWITCH (w/o Dynamic Laser Cruise Control System)

a.

Measure the resistance according to the value(s) in the table below.

E337702E04
2.479,3.01 2.698,3.01 false 3.385,3.031 3.604,3.031 false 3.99,2.052 4.615,2.24 0.625,0.188 10 false CANCEL 6.333,1.125 6.958,1.313 0.625,0.188 10 false ON/OFF 0.104,0.083 1.802,0.656 1.698,0.573 10 false Component without harness connected: (Cruise Control Main Switch) 4.042,0.115 5.229,0.521 1.188,0.406 10 false + RES (RESUME/ACCEL) 4.813,2.313 6.802,2.51 1.99,0.198 10 false - SET (SET/COAST) 3.656,2.948 3.969,3.146 0.313,0.198 10 false ECC 2.167,2.938 2.625,3.135 0.458,0.198 10 false CCS

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (ECC) - 3 (CCS) Neutral 10 kΩ or higher
1 (ECC) - 3 (CCS) +RES 235 to 245 Ω
1 (ECC) - 3 (CCS) -SET 620 to 640 Ω
1 (ECC) - 3 (CCS) CANCEL 1510 to 1570 Ω
1 (ECC) - 3 (CCS) Main Switch off 10 kΩ or higher
1 (ECC) - 3 (CCS) Main Switch on Below 1 Ω


If the result is not as specified, replace the cruise control main switch.


Hide 84632 2.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Dynamic Laser Cruise Control System)

a.

Measure the resistance according to the value(s) in the table below.

E345248E02
2.573,3.042 2.333,3.042 false 2.906,2.927 2.354,2.573 false 3.271,3 3.479,2.802 false 5.448,0.313 6.063,0.51 0.615,0.198 10 false MODE 6.083,1.031 7,1.229 0.917,0.198 10 false ON-OFF 3.99,2.052 4.906,2.25 0.917,0.198 10 false CANCEL 0.083,0.115 1.792,0.635 1.708,0.521 10 false Component without harness connected: (Cruise Control Main Switch) 3.313,0.198 4.49,0.542 1.177,0.344 10 false + RES (RESUME/ACCEL) 4.854,2.323 6.115,2.531 1.26,0.208 10 false - SET (SET/COAST) 2.031,2.969 2.49,3.167 0.458,0.198 10 false CCS 2.104,2.469 2.563,2.667 0.458,0.198 10 false R/N 3.51,2.719 3.802,2.906 0.292,0.188 10 false ECC

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (ECC) - 2 (R/N) Neutral 10 kΩ or higher
1 (ECC) - 3 (CCS) Neutral 10 kΩ or higher
1 (ECC) - 3 (CCS) +RES 235 to 245 Ω
1 (ECC) - 3 (CCS) -SET 620 to 640 Ω
1 (ECC) - 3 (CCS) CANCEL 1510 to 1570 Ω
1 (ECC) - 3 (CCS) Main Switch off 10 kΩ or higher
1 (ECC) - 3 (CCS) Main Switch on Below 1 Ω
1 (ECC) - 2 (R/N) Main Switch on and MODE Switch on Below 1 Ω


If the result is not as specified, replace the cruise control main switch.