Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235643 CRUISE CONTROL MAIN SWITCH A

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 45187 4.REMOVE LOWER NO. 3 STEERING WHEEL COVER

Hide 84632 6.REMOVE CRUISE CONTROL MAIN SWITCH

a.
B348978

Disconnect the connector.


b.

Remove the 2 screws and cruise control main switch.