Home › Drivetrain › AB60F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM27L0U _52 Drivetrain _049310 AB60F AUTOMATIC TRANSMISSION / TRANSAXLE _0235648 PARK / NEUTRAL POSITION SWITCH A

AB60F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


a.

Install the switch to the manual valve shaft.


b.
C161110

Temporarily install the bolt.


c.
C161109E01
1.99,0.031 3.177,0.210 1.187,0.179 10 New Lock Washer 1.795,1.111 1.894,0.119 1.894,0.119 1.97,0.119 false

Install a new lock washer and the nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.
C161107

Temporarily install the control shaft lever RH.


e.
C155873E04
1.906,0.052 2.052,0.219 0.146,0.167 10 false N 1.021,0.302 1.146,0.469 0.125,0.167 10 false P 1.573,0.292 1.719,0.458 0.146,0.167 10 false R

Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.


f.

Remove the control shaft lever RH.


g.
U152677E02
1.979,1.552 0.698,1.229 false 1.969,0.927 1.74,0.115 1.74,0.115 1.917,0.115 true 2.906,0.479 2.865,0.531 false 2.771,0.594 2.76,0.615 false 2.885,0.427 2.813,0.542 false 2.833,0.438 2.719,0.594 false 2.771,0.448 2.677,0.583 false 2.74,0.417 2.646,0.573 false 2.708,0.396 2.604,0.552 false 2.583,0.5 2.563,0.542 false 1.969,0.052 3.146,0.281 1.177,0.229 10 false Neutral Basic Line 0.229,1.115 0.76,1.313 0.531,0.198 10 false Groove

Align the groove with the neutral basic line.


h.

Hold the switch in the position described above and tighten the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


i.
C161108

Using a screwdriver, bend the tabs of the lock washer.


j.
C161107

Install the transmission control shaft lever RH with the spring washer and nut.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


k.

Connect the switch connector.


Hide 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C161106

a.

Connect the cable with the nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:

When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the outside of the vehicle.