AB60F AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM
- PRECAUTION
- DEFINITION OF TERMS
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- ROAD TEST
- MECHANICAL SYSTEM TESTS
- HYDRAULIC TEST
- MANUAL SHIFTING TEST
- INITIALIZATION
- MONITOR DRIVE PATTERN
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- P2757 Lock-up does not occur when driving in the lock-up range (normal driving at 80 km/h (50 mph)), or lock-up...
- P2759 Open or short is detected in shift solenoid valve SLU circuit for 1 second or more while driving (1 trip...
- P2772 Transfer 4L position switch remains ON while vehicle is running under following conditions for 1.8 sec. or...2015.08–2016.10from 2016.10
- P2742, P2743
- P2716 Open or short is detected in shift solenoid valve SLT circuit for 1 second or more while driving (1 trip...
- P0985, P0986
- P0982, P0983
- P0979, P0980
- P0976, P0977
- P0973, P0974
- P0894, P2714
- P0781 When conditions (a) and (b), or (a) and (c) are met. (2-trip detection logic) (a) When the ECM directs the...
- P0778 The ECM checks for an open or short in the shift solenoid valve SL2 circuit while driving and shifting gears...
- P0766, P0776
- P0761 S3 stuck ON malfunction*1: When the ECM directs the gearshift to switch to 5th or 6th gear, the engine...
- P0756 S2 stuck ON malfunction*1: Shifting to 3rd and 5th gears is impossible. The ECM determines there is a...
- P0751 S1 stuck ON malfunction*1: The ECM determines there is a malfunction when the following conditions are both...
- P0748 The ECM checks for an open or short in the shift solenoid valve SL1 circuit while driving and shifting...
- P0729 6th gearshift malfunction: The ECM determines there is a malfunction when both of the following conditions...
- P0722 All conditions below are detected 5 seconds or more continuously (2-trip detection logic) (a) No signal from...
- P0717 All conditions below are detected for 5 seconds or more (1-trip detection logic) (a) Gear change is not...
- P0712, P0713
- P0705 When one of following conditions is met: (A) Any 2 or more of the following signals are ON simultaneously (2...
- P0711 Either condition is met (2-trip detection logic): (a) Certain monitor enabling conditions are met and the ATF...2015.08–2016.10from 2016.10
- Transmission Control Switch Circuit
- Pattern Select Switch Circuit
- Preparation
AUTOMATIC TRANSMISSION FLUID
SPEED SENSOR
TRANSMISSION WIRE
VALVE BODY ASSEMBLY
PARK / NEUTRAL POSITION SWITCH
OIL COOLER
SHIFT LEVER
TRANSMISSION CONTROL CABLE
AUTOMATIC TRANSMISSION ASSEMBLY
AUTOMATIC TRANSMISSION UNIT
TORQUE CONVERTER CLUTCH AND DRIVE PLATE
OIL PUMP