Home › Drivetrain › AB60E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL COOLER
RM27L0U _52 Drivetrain _049311 AB60E AUTOMATIC TRANSMISSION / TRANSAXLE _0235668 OIL COOLER A

AB60E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL COOLER  INSTALLATION  


PROCEDURE

Hide 33490F 1.INSTALL TRANSMISSION OIL COOLER ASSEMBLY

a.
U153528E02
2.927,4.208 1.49,4.208 1.49,4.208 2.802,4 true 1.563,3.51 2.125,2.813 2.125,2.813 1.802,3.469 true 0.719,4.094 1.542,4.313 0.823,0.219 10 false New O-Ring 2.083,2.635 2.906,2.854 0.823,0.219 10 false New O-Ring 0.396,1.219 0.51,1.375 0.115,0.156 10 false A 0.719,0.354 0.833,0.51 0.115,0.156 10 false B 2.24,0.823 2.354,0.979 0.115,0.156 10 false B

Coat 4 new O-rings with ATF.


b.

Install the 4 O-rings, transmission oil cooler spacer and transmission oil cooler to the automatic transmission.


c.

Temporarily install the bolt A.


d.

Install the 2 bolts B and tighten them to the specified torque. Then tighten bolt A to the specified torque.

Torque:
21 N*m (214 kgf*cm, 16 ft.*lbf)


Hide 2.CONNECT WATER BY-PASS PIPE ASSEMBLY

a.
U153540E02
1.573,3.271 1.552,3.219 false 1.531,3.115 1.521,3.104 false 1.594,3.26 1.552,3.156 false 1.594,3.198 1.531,3.063 false 1.594,3.146 1.542,3.021 false 1.615,3.115 1.552,2.99 false 1.625,3.083 1.563,2.948 false 1.594,2.948 1.573,2.917 false 2.708,0.427 1.906,0.219 true 1.729,2.677 2,2.865 0.271,0.188 10 false RH 1.396,0.115 1.938,0.313 0.542,0.198 10 true Stopper

Connect the 2 water by-pass hoses with the 2 clips and install the water by-pass pipe with the bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

HINT:

Make sure the pinching portion of each clip is facing the direction shown in the illustration.



Hide 5.ADJUST AUTOMATIC TRANSMISSION FLUID

Hide 6.INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK

Hide 8.INSPECT FOR EXHAUST GAS LEAK