Home › Drivetrain › AXLE AND DIFFERENTIAL › AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD)
RM27L0U _52 Drivetrain _049314 AXLE AND DIFFERENTIAL _0235692 AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD) A

AXLE AND DIFFERENTIAL  AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD)  INSTALLATION  


PROCEDURE

Hide 41400 1.INSTALL AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR

a.
C159278E03
1.097,1.797 1.279,1.956 0.183,0.159 10 *a 1.499,1.441 1.499,1.9 1.499,1.9 1.293,1.9 false

Remove any old FIPG material and be careful not to drop oil on the contact surfaces of the differential tube and actuator.

Text in Illustration
*a Seal Packing


b.

Clean the contact surfaces with any residual FIPG material using gasoline or alcohol.


c.

Apply seal packing to the differential tube as shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent


HINT:

Install the actuator within 10 minutes of applying seal packing.



d.
C159797

Clean the threads of the 4 bolts and retainer bolt holes with toluene or trichloroethylene.


e.

Install the actuator onto the differential tube.


f.

Apply adhesive to 2 to 3 threads of each bolt end.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



g.

Install the 4 bolts.

Torque:
21 N*m (209 kgf*cm, 15 ft.*lbf)


h.

Connect the actuator hose.


i.

Connect the actuator connector.


Hide 3.INSPECT FOR OIL LEAK