Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM27L0U _52 Drivetrain _049314 AXLE AND DIFFERENTIAL _0235698 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE PARKING BRAKE ASSEMBLY

Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C181038

Using a dial indicator, check for looseness near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Ensure that the dial indicator is set at a right angle to the measurement surface.


If the looseness exceeds the maximum, replace the axle hub.


Hide 3.INSPECT REAR AXLE HUB RUNOUT

a.
C181039

Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

Maximum:

0.05 mm (0.0020 in.)


NOTICE:

Ensure that the dial indicator is set at a right angle to the measurement surface.


If the runout exceeds the maximum, replace the axle hub.


Hide 4.INSTALL PARKING BRAKE ASSEMBLY