Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235712 AIR SUSPENSION SYSTEM C

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  U0124  Lost Communication with Lateral Acceleration Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0140  Lost Communication with Body Control Module  


DESCRIPTION

The suspension control ECU inputs signals from the skid control ECU and ECM via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

DTC Code Detection Condition Trouble Area
U0100 While driving at 30 km/h (19 mph), CAN communication between suspension control ECU and ECM stops for 3 seconds or more.
·

CAN communication line

·

ECM

·

Suspension control ECU


U0122 CAN communication between suspension control ECU and Skid control ECU stops for 3 seconds or more.
·

CAN communication line

·

Skid control ECU

·

Suspension control ECU


U0124 CAN communication between suspension control ECU and yaw rate and acceleration sensor stops for 3 seconds or more.
·

CAN communication line

·

Yaw rate and acceleration sensor

·

Suspension control ECU


U0126 CAN communication between suspension control ECU and steering angle sensor stops for 3 seconds or more.
·

CAN communication line

·

Steering angle sensor

·

Suspension control ECU


U0140 CAN communication between suspension control ECU and main body ECU stops for 3 seconds or more.
·

CAN communication line

·

Main body ECU (Cowl side junction block LH)

·

Suspension control ECU



CAUTION / NOTICE / HINT

NOTICE:

After replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).


PROCEDURE

1.CHECK FOR DTC

b.

Perform a road test.


c.

Check if DTC U0100, U0122, U0124, U0126 or U0140 are output (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B

HINT:

If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.




A

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B