Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235712 AIR SUSPENSION SYSTEM C

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  C1789  Vehicle Identification Malfunction  


DESCRIPTION

·

This DTC is stored when the suspension control ECU is initialized and is cleared when the vehicle identification information received through the CAN communication system is correctly stored in the EEPROM.

·

DTC C1789 is stored when an incorrect ECM is installed, as the vehicle specification and data do not match.


DTC Code Detection Condition Trouble Area
C1789 Either condition is met:
·

The vehicle identification information is not stored.

·

The information stored in the suspension control ECU and the vehicle identification information received through the CAN communication system do not match.


·

Suspension control ECU

·

ECM



CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).

·

Do not exchange the suspension control ECU with a normally functioning one from another vehicle to perform troubleshooting.



PROCEDURE

1.PERFORM REGISTRATION

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check if DTC C1789 is output (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C1789 is not output.




OK

END

NG

3.CHECK PART NUMBER
3.CHECK PART NUMBER
a.

Check that the part number of the installed ECM is correct (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>ECM>REMOVAL for 3UR-FE, See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>ECM>REMOVAL for 3UR-FBE).

NOTICE:

When removing the ECM to check the part number, or when replacing the ECM, be sure to follow the appropriate procedures and precautions.


OK:

ECM with correct part number is installed.


Result
Result Proceed to
OK A
NG for 3UR-FE B
for 3UR-FBE C



A

4.CLEAR DTC

B

C

4.CLEAR DTC

NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC
a.

Check if DTC C1789 is output (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C1789 is not output.


HINT:

If no parts are replaced and DTC C1789 is output, there may be an internal malfunction in the suspension control ECU. In this case, replace the suspension control ECU.




OK

NG

REPLACE SUSPENSION CONTROL ECU