Home › Suspension › REAR SUSPENSION › REAR PNEUMATIC CYLINDER
RM27L0U _53 Suspension _049318 REAR SUSPENSION _0235728 REAR PNEUMATIC CYLINDER A

REAR SUSPENSION  REAR PNEUMATIC CYLINDER  INSTALLATION  


PROCEDURE

Hide 48090B 1.INSTALL REAR PNEUMATIC CYLINDER ASSEMBLY LH

a.
U153629E01
0.599,1.113 0.935,1.333 0.336,0.220 10 45° 0.41,0.11 0.768,0.270 0.358,0.159 10 Front

Install the pneumatic cylinder as shown in the illustration.

HINT:

Rotate the pneumatic cylinder to fasten the pneumatic cylinder into the spring seat on the frame.



b.

Connect the height control tube (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM>PRECAUTION).


c.
C180769

Install a new clip.


d.
C181283E02
2.385,1.427 2.26,1.427 2.26,1.427 1.615,3.156 true 0.396,1.833 0.521,1.833 0.521,1.833 1.198,3 true 2.427,1.354 3.302,1.99 0.875,0.635 10 true No. 2 Lower Arm 0.146,1.76 0.417,2.125 0.271,0.365 10 true Pin

Lower the lift that is supporting the frame to allow the tire to touch the floor and check that the piston-side pneumatic cylinder pin is in the center hole of the No. 2 lower arm.


e.

Start the engine to fill the pneumatic cylinder with air.


f.
C180770

Install the bolt.

Torque:
17 N*m (173 kgf*cm, 13 ft.*lbf)