Home › Suspension › REAR SUSPENSION › REAR PNEUMATIC CYLINDER
RM27L0U _53 Suspension _049318 REAR SUSPENSION _0235728 REAR PNEUMATIC CYLINDER A

REAR SUSPENSION  REAR PNEUMATIC CYLINDER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not extend the pneumatic cylinder during or after removal.

·

Do not put air in the pneumatic cylinder when it is removed from the vehicle.

·

Do not remove the pneumatic cylinder from the vehicle without releasing the air first.

·

When the pneumatic cylinder is fitted on the vehicle, do not remove the absorber. Doing so will cause the No. 2 lower arm to move beyond its normal stroke in the rebound direction.

·

Do not remove the bolt from the bottom of the pneumatic cylinder if the pneumatic cylinder is not filled with air.

·

When performing this procedure, support the vehicle frame and maintain the No. 2 lower arm height at a position lower than the normal vehicle height.



PROCEDURE

Hide 48090B 1.REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH

a.
C180774

Insert a piece of wood between the jack and the No. 2 lower arm, and raise the No. 2 lower arm.


b.
C180770

Remove the bolt.


c.
C180769

Remove the clip on the upper side of the rear pneumatic cylinder.


d.

Disconnect the height control tube (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM>PRECAUTION).


e.

Gently lower the jack and remove the rear pneumatic cylinder.